After the even surface on the floor is put on the sealing of defects or the use of a grinding machine or laying chipboard plates, the actual laying of parquet boards begins. In this case, the work begins with the center of the room. Moreover, it is determined using two cords, which are carried out from the middle of the walls through the middle of the room. The intersection point is the center.
Parquet boards are laid along the installed lines-intransigns, while it will be seen whether the last parquet boards should be laid from the walls. By the way, in the repair, the price of this material was often not very high in the repair.
So that the parquet boards cut by the walls of the room are one size, they make a displacement of the central point of the room, before that, not forgetting about the preliminary markup made..
Next, glue is applied to the area of the room where the first four strips will be located, which, after placement, must be carefully pressed to the glued area. The rest of the boards are laid in the same way.
One by one, thus, square parquets are gradually obtained. To facilitate the fit at the end of the styling, all considered complex areas around the perimeter of the room are laid lastly. Thus, parquet boards are laid.