Tiles can be used to finish any rooms. It does not rot, does not dust, does not burn and is very resistant to the effects of chemical components. To begin with, the surface of the floor or wall is prepared, all pollution and irregularities are removed from it. You should use a special glue for tiles, having previously carefully studied the instructions on the package. If the proportions are correctly observed when mixing glue with water, then it will turn out to be the desired consistency.
Tiles must begin to lay down from the far corner of the room. It is advisable to use the two spatulas. We apply an even layer of glue to the tile with the first spatula, we apply the same layer of glue to the floor or wall (directly to the place where the tile will be laid). Immediately after laying, you need to see if the tile is even light. If not evenly, then it needs to be corrected, then pressed to the surface until the glue is grasped. When laying tiles, plastic spacers in the form of crosses should be used. They will help to observe the desired distance between the tiles. Glue that has fallen on the front side of the tiles must be urgently removed using a piece of fabric and warm water. Then it is necessary to extract plastic crosses and grout with a roller and a special solution.